Topic: cutter throttle controls (Read 1682 times)

empire · « **on:** August 30, 2010, 13:22:20 »

i noticed on the cutters throttle controls there is a knob u can turn but i doesnt seem to do anything. what does it control?

mvsmith · « **Reply #1 on:** August 30, 2010, 13:28:41 »

http://80.95.161.114/shipsim/forum/index.php/topic,20296.0.html (http://80.95.161.114/shipsim/forum/index.php/topic,20296.0.html)

empire · « **Reply #2 on:** August 30, 2010, 18:59:59 »

i read that already thats not what i'm talking about. i know which controls are for the azipod; i'm talking about the main engines throttle controls there is a knob that you can turn. thats what i'm trying to figure out what its for

LucAtC · « **Reply #3 on:** August 30, 2010, 19:35:20 »

Hello Empire,

Striking back : There is nothing assigned to this knob. What do you think its use could be (except locking the position of the levers) ?

Regards,
Luc

empire · « **Reply #4 on:** August 30, 2010, 21:27:19 »

yea not sure but thanks for your reply at least i can stop trying to figure out what it does

kAAmAA · « **Reply #5 on:** September 24, 2010, 03:56:17 »

I have seen them use a very similar setup on "Whale Wars". They manually operate this knob that is on the back of the throttle control assembly. They seem to be adjusting or trimming some component of the propulsion system (pitch?). Very curious what this is.

Author Topic: cutter throttle controls (Read 1682 times)

empire

cutter throttle controls

mvsmith

Re: cutter throttle controls

empire

Re: cutter throttle controls

LucAtC

Re: cutter throttle controls

empire

Re: cutter throttle controls

kAAmAA

Re: cutter throttle controls