Ship Simulator
English forum => Ship Simulator Extremes => General discussions => Topic started by: scand on September 01, 2011, 06:19:34
-
I have all the downloads and patches installed, where did I miss it? How to correct my mistake?
BTW I Have it on the XP hardrive on this PC and Ferry 02 Campaign went flawlessly to conclusion.
I believe that alot of problems are Window 7 related!
Thanks!
Alex S.
-
I have all the downloads and patches installed, where did I miss it? How to correct my mistake?
BTW I Have it on the XP hardrive on this PC and Ferry 02 Campaign went flawlessly to conclusion.
I believe that alot of problems are Window 7 related!
Thanks!
Alex S.
Hold on a sec, Is this Ship Sim, what one ?? I thinks this will get more attention if it was in Technical Support. Ship Sim and Windows 7 are doing good, not sure what the problems is here. Is this Steam Version of Ship Sim or Non-Steam version??
-
This is Ship SS Extremes purchased from SS Website. Evidently within Windows 7 Ultimate I could not advance into another Environment. I am running now a Dual HD with Windows 7 on one and XP on the other. I installed Extremes using my keys from SS Web Page installed and loaded everything I had purchased. However I missed something in the installtion. The error appears on the download option within Extremes.
It is installed correctly in Windows7.
Alex S.
-
This is Ship SS Extremes purchased from SS Website. Evidently within Windows 7 Ultimate I could not advance into another Environment. I am running now a Dual HD with Windows 7 on one and XP on the other. I installed Extremes using my keys from SS Web Page installed and loaded everything I had purchased. However I missed something in the installtion. The error appears on the download option within Extremes.
It is installed correctly in Windows7.
Alex S.
The good news is you should be able to re-download the Sim more than once as Im thinking it's a corrupt download. More good news is that SSE works flawlessly on Windows 7 so there should not be any problems. Try to re-download SSE again and then re-install with the new download
Third
-
Third
Thanks for the Info!
However it is worst then originally . I did two clean PC rebootings with the unintall/installation procedures. I noticed the full version of the program is 1.3.5! Does one have to have the extractor program installed to use it? I believe the problem lies in the installation including the extraction of the main program or the problem could be elsewhere, out of my control. All I know is it works fine on XP.
I have tried saving and the on the other attempt used RUN as the option. The results both times were the same!
I have had this problem from the start on Windows 7. Do you recall what the original size was of version 1.1?
Thanks Again!
scand
[Alex S.]